Unit A button Assignment

In this menu, a maximum of 9 system units is assigned to numeric buttons 1-9 regardless of unit address.

This is to avoid double-digit unit addresses which can occur in a large system with many units connected and could confuse operators.

A frequently used system unit can be easily selected in nor- mal operation by pressing one numeric button and then the UNIT A button.

1.Display [UA-no] and press the CAM/SET button. The LED displays [A1-01] while “1” following A blinks.

The first 2 digits from A1 to A9, “A numbers”, stand for numeric buttons from 1 to 9 to be pressed prior to UNIT A button in normal operation. The next 2 digits are the unit address assigned in the following procedures.

The default setting is shown below.

A1-01

A2-02

A3-03

A1-04

A5-05

A6-06

A7-07

A8-08

A9-09

2.Select an “A number” entering a number from 1 to 9, then press the CAM/SET button. The LED displays “A number” A3 when numeric button 3 is entered for example.

Available A numbers: 1-9

3.Press the CAM/SET button to validate the selection. The LED displays [A3-03] while the next two digits are blink- ing.

4.Enter a 2-digit unit address that you wish to assign to the “A number” (e.g., A3), then press the CAM/SET but- ton. The LED displays [A3-99], for example, when you enter unit address 99.

Available addresses: 01-99

5.Press the CAM/SET button to validate the selection. Repeat above the steps 2 to 5 as needed.

6.Press the ESC button to go back to the previous menu.

Unit B button Assignment

The UNIT B button is set up in the same way as the UNIT A button for use in normal operation. Refer to the above description for Unit A button Assignment.

User Password

In this menu, a 5-digit password for user authorization is registered.

1.Display [UsrP ] and press the CAM/SET button. The LED displays the registered password.

2.Enter a 5-digit password with the numeric buttons. The default setting is [12345].

Available password digits: 00000-99999

3.Press the CAM/SET button to validate the selection.

4.Press the ESC button to go back to the previous menu.

Administrator Password

In this menu, a 5-digit password for administrator certifica- tion is registered.

1.Display [SUsrP] and press the CAM/SET button. The LED displays the registered password.

2.Enter a 5-digit password with the numeric buttons. The default setting is [12345].

Available password digits: 00000-99999

3.Press the CAM/SET button to validate the selection.

4.Press the ESC button to go back to the previous menu.

User Password Certification

In this menu, password certification in normal operation is enabled or disabled.

1.Display [USr-C] and press the CAM/SET button. The LED displays [UC-on] or [UC-oF].

2.Select On or Off with the joystick controller. The default setting is On.

on: Password certification enabled.

oF: Password certification disabled.

3.Press the CAM/SET button to confirm the selection.

4.Press the ESC button to go back to the previous menu.

20

Page 20
Image 20
Panasonic WV-CU360C manual Unit a button Assignment, Unit B button Assignment, User Password, Administrator Password