■System Unit Selection
Connected system units can be selected either by their unit number
●Selecting with Unit Number
1.Enter a unit number
●Selecting with UNIT A/UNIT B Button
The unit numbers
1.Enter a single digit number
Omit this step when you wish to select unit number “1”, as this unit is selected by default.
MONCAM
ESC LOGOUT SET
2.Press the SHIFT button to turn the shift indicator on, then press the UNIT A/UNIT button.
UNIT A
then
SHIFTUNIT
The selected unit number appears in the unit section of the LED display.
The selected camera number appears in the camera section of the LED display.
Notes:
•To confirm the selected unit number when the moni- tor number appears in the unit section of the LED display, take procedure 2 or press MON/ESC but- ton .
•If no unit is connected, [Err] appears a few seconds after unit selection. In such a case, confirm the unit address and repeat the above procedure.
•If the unit address of a system unit is unknown, con- sult your system administrator.
•When multiple system units such as Data Multiplex Unit are connected to the System Controller and the UNIT A or UNIT B button is pressed, the camera number on the controller's LED display will not agree with the camera picture on the monitor.
In this case, select the monitor and camera as described on the next page.
MONCAM
ESC LOGOUT SET
2.Press the UNIT A or UNIT B button while the SHIFT indicator is off.
UNIT A | UNIT B |
or
UNIT
The selected unit address appears in the unit section of the LED display.
The selected camera number appears in the camera section of the LED display.
24
