Panasonic WV-CU360C manual Iris buttons Iris CLOSE/OPEN, Focus buttons Focus NEAR/FAR

uJoystick Controller (UP/DOWN/L/R)

Used to operate the Pan/Tilt Head manually, or to move the cursor to the desired position on the SETUP MENU of the Matrix Switcher.

UP:Upward

DOWN: Downward

L:Left

R:Right

i Iris buttons (IRIS CLOSE/OPEN)

Close or open the lens iris of cameras equipped with the specified lens.

When these buttons are pressed at the same time, the lens iris is reset to the factory setting.

oFocus buttons (FOCUS NEAR/FAR)

Adjust the lens focus of cameras equipped with the specified lens.

When these buttons are pressed at the same time, the lens focus is set automatically when the specified cam- era, such as the WV-CS854, is used.

!0Zoom buttons (ZOOM TELE/WIDE)

Zoom the image in or out if the camera is equipped with the specified lens.

!1Auxiliary button (AUX)

In combination with the number buttons 1 to 4, controls the Auxiliary switches for the Receiver, Wiper and Defroster.

Press the numeric button, then press this button to turn the Auxiliary switches for the Wiper or Defroster On or Off.

1:Auxiliary Switch 1

2:Auxiliary Switch 2

3:Wiper

4:Defroster

!2Panning button (PAN)

In combination with the numeric button 1 or 2, is used to control the panning mode of the Pan/Tilt Head.

Press the numeric button, then press this button to turn the Panning mode On and Off.

1:Auto Panning Mode

2:Random Panning Mode

!3Preset Position button (PRESET POSI/CAM POSI)

In combination with the numeric buttons, moves the camera to the desired preset position. Also selects a camera position by a serial number assigned indepen- dently of the camera number. Specify a number, then press ALT and finally this button.

!4Camera/Set button (CAM (SET))

CAM: Used for camera selection. To select a camera, enter the desired camera number with the numeric buttons, and then press this button.

SET: Executes the currently highlighted setting in the setup menu of the Matrix Switcher and opens a submenu.

!5Numeric buttons (0 - 9)

These buttons are used for numerical input such as camera and monitor selection, sequence and preset position, etc.

Buttons 2, 4, 6 and 8 are also used to move the cursor to the desired position on the Camera’s Set Up Menu.

!6Monitor/Escape button (MON (ESC))

MON: Used for monitor selection. To select a monitor, enter the monitor number with the numeric buttons, and then press this button.

ESC: Escapes from or executes the currently highlight- ed selection in the setup menu of the matrix switch- er.

!7Alternate button (ALT)

Alternates the function of dual-function buttons between the normal and the alternate function. It also enables the CAM MENU button and SET UP button to display the assigned menu or setup table on the selected moni- tor.

The indicator is lit while the function mode is selected.

!8Sequence Pause button (PAUSE)

Pauses a sequence that is being run on the selected monitor.

!9Function button (FUNCTION)

Pressing this button in combination with another opera- tion button activates a specific function.

@0Alarm Acknowledgment and Reset button (ACK/RESET)

Cancels an activated alarm. To cancel the alarm, the monitor must first be selected.

Press this button once to acknowledge the activated alarm (the indicator blinks rapidly), then press it again to reset the alarm.

55