■Camera Preset Position
There are two ways of presetting camera positions.
One is to use the camera setup menu of the combination camera and the other is to operate the System Controller as follows.
1.Select the desired system unit, monitor and camera.
2.Move the camera to a position you wish to preset, using the joystick.
UP
LR
DOWN
Adjust the picture using the following buttons.
•Iris (Open/Close)
•Focus (Far/Near)
•Zoom (Tele/Wide)
Note: The memorized parameters may differ somewhat depending on the camera type. Refer to the manual included with the camera.
3.Type a number with the numeric buttons for the pre- set position. The typed number appears in the CAMERA section of the LED display.
4.Press the HOME/PRESET/PROGRAM PRESET button while holding down the PROGRAM/CAM SETUP/CAM FUNCTION button.
The position and its number are memorized for later recall.
PROGRAM | HOME/PRESET |
CAM SETUP |
|
| PROGRAM |
CAM FUNCTION | PRESET |
|
MONCAM
ESC LOGOUT SET
37
