Panasonic WV-CU360C manual General Setup, Shortcut for Preset Position Setup

■Camera Setup

The cameras connected to the WJ-FS616/FS616C are set up from the controller.

Note: Make sure that the multiplexer and the controller are set to identical communication parameters.

●General Setup

1.Select a camera pressing the numeric buttons, then press the CAM/SET button.

2.Press the CAMERA SET ON button. The ON indicator is lit while the CAMERA SET UP MENU is displayed on the monitor.

CAMERA SET

ONOFF

T/L MODE

3.Select a setup item by moving the joystick up and down. Select a parameter by moving the joystick to the right or left, then press the CAM/SET button to validate the selection or to enter a submenu.

UP

CAM

LR

SET

DOWN

4.Press the UNIT/ESC button to execute the selection and to return the menu to a higher layer.

UNIT

ESC

5.Press the SEQUENCE button to enter the SPECIAL menu.

SEQUENCE

6.Press the VTR/CAM button to reset all functions to the defaults, or press the SEQUENCE button to reset a selected function.

VTR

CAM

7.Press the CAMERA SET OFF button to close the cam- era setup menu.

CAMERA SET

ONOFF

T/L MODE

●Shortcut for Preset Position Setup

A shortcut can be created for setting a camera position without going through the whole presetting process. Shortcuts are applicable only to cameras having the preset- ting function.

1.Open the PRESET menu of the camera.

2.Press the ALT button while the position setting menu is displayed.

3.Move the camera with the joystick to the position you wish to preset.

4.Adjust the picture with the IRIS, FOCUS and ZOOM buttons.

5.Press the ALT button again. The preset conditions are registered, and the joystick function reverts to moving the cursor.

51