Pioneer SX-LX03 manual Troubleshooting, Playback, Additional information, Chapter, Problem, Check

Additional information 07

Chapter 7

Additional information

Troubleshooting

Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical appliances being used. If the trouble cannot be rectified even after checking the points below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.

Playback

Problem

Disc does not play. Disc tray opens automatically.

Check	Remedy
Is the disc scratched?	It may not be possible to play scratched discs.
Is the disc dirty?	Clean the disc (see the Blu-ray disc player’s operating
	instructions).
Is the disc properly set in the	• Set the disc with the printed side facing up.
disc tray?	• Set the disc properly in the depression in the disc tray.
Is the region number correct?	The region numbers of discs that can be played on this set
	are as shown below (page 74).
	• BDs: “B” (or including “B”) and “ALL”
	• DVDs: “2” (or including “2”) and “ALL”
Is the player set in a humid	There could be condensation inside. Wait for the
place?	condensation to dissipate. Do not set the player near an air-
	conditioner, etc. (see the Blu-ray disc player’s operating
	instructions).

Picture freezes and the front panel and remote control buttons stop working.

•Press  (stop) to stop playback, then restart playback.

•If the playback cannot be stopped, press  STANDBY/ON on the player’s front panel to turn off the power, then turn the power back on.

•If the power cannot be turned off, press and hold

STANDBY/ON on the player’s front panel for over 5 seconds. The power will turn off.

123

En