Pioneer SX-LX03 manual 06Connecting an iPod, Switching the iPod controls1

06Connecting an iPod

Important

If an error message lights in the front panel display, try following the points below:

Symptom What it means

Error I1 There is a problem with the signal path from the iPod to the unit. Switch off the unit and reconnect the iPod to the unit. If this doesn’t seem to work, try resetting your iPod.

Error I2 The software version being used with the iPod needs to be updated. Update the software being used with the iPod (please use the latest iPod software versions later than the iPod updater 2004-10-20).

Error I3 The iPod that is not supported is connected. Check whether the iPod was supported by this unit (page 36).

When the iPod software version is too old, update the iPod software to the latest version.

Error I4 When there is no response from the iPod, update the iPod software to the latest version. If this doesn’t seem to work, try resetting your iPod.

iPod Error The power requirements of the iPod are too high for this unit.

No Music There are no playable songs currently

Track stored in the iPod. Input some music files compatible with iPod playback.

No Track When there are no tracks in the category selected on the iPod. Select a different category.

Switching the iPod controls1

You can switch over the iPod controls between the iPod and the unit.

1 AUDIOCTRL Press to switch the iPod controls.2

This will enable the controls and display on your iPod; simultaneously, this unit’s remote control unit will be disabled.

2 AUDIOCTRL Press again to switch back to the receiver controls.

iPod is a trademark of Apple Inc., registered in the U.S. and other countries.

Note

1You cannot use this function, when an iPod of fifth generation or iPod nano of first generation is connected.

2When this function is set, iPod images cannot be played on this unit.

38

En