Pioneer SX-LX03 Speaker Setup Guide LX03BD, Black –Red + Color-codedwire, Y-cable To receiver

Speaker Setup Guide (LX03BD) 02

•You may purchase and use your own speaker cables if desired. For details, see Using your own speaker cables on page 22.

•The front and surround speaker cables have a color-coded connector at one end and two bare wires at the other end.

•Two purple cables are provided for the subwoofer, one 4 meters and the other 10 meters in length. Use the appropriate cord depending on the length needed for the installation location.

Color-coded wire (Connect to speaker)

Color-coded connector (Connect to rear panel)

•Since there is only one terminal to connect the two center speakers, you will need to use the supplied Y-cable for the connection.

•Twist and pull off the protective shields on each wire.

•Connect the wires to the speaker. Each speaker in the illustration can be identified by means of the color-coded indicator provided on the rear-surface label.

Match the color-coded wire with the color indicator on the label, then insert the color- coded wire into the red (+) side and the other wire into the black (–) side.

Black (–) Red (+)

Color-coded wire

•When connecting the center speakers, connect the Y-cable dual end to the two center speakers in the same way.

Y-cable

To receiver

•Connect the other end to the color-coded speaker terminals on the rear of the receiver. Make sure to insert completely.

The small lug at the wire-end of the speaker plug should face up or down depending on whether it’s being plugged into one of the upper or lower speaker terminals. Please make sure to connect correctly.

Upper terminal Lower terminal

•Fasten the cables together with the spiral wrap.

Hold multiple cables together and place the wrap over the cables from the end. Wrap the spiral wrap with the cables in the center.

The spiral wrap may be cut at a desired length.

English Deutsch Français Italiano Nederlands Español

21

En