Pioneer SX-LX03 manual Additional information, Problem, Remedy

Models: SX-LX03

1 132
Download 132 pages 11.5 Kb
Page 61
Image 61
Manual background

Additional information

11

Problem

Remedy

No audio signal is

Audio input from ANALOG RCA jacks cannot be output from AUDIO OUT

output from AUDIO

jacks.

OUT jacks.

 

 

 

No sound from

Check the speaker level settings (see Channel level setting on page 43).

subwoofer.

SX-LX08 model only:

 

– Check subwoofer for correct connections (see Connect the speakers on

 

page 24).

 

– Be sure subwoofer's power is turned ON.

 

– Raise subwoofer's volume level.

 

 

Can’t operate using the

• Replace the batteries (see Putting the batteries in the remote control on page 9).

remote control.

• Operate within 7 m, 30° of the remote sensor (see Using the remote control on

 

page 9).

 

• Remove any obstacles or operate from another position.

 

• Avoid exposing the remote sensor on the front panel to direct light.

 

• Check that there’s nothing mistakenly plugged into the CONTROL IN jack.

 

• For operating the other Pioneer component connected to the CONTROL OUT

 

jack of this unit, make sure that the control cable and either an HDMI or analog

 

audio cable are connected (page 49).

 

• If an object is placed on top of the touch sensor, the sensor will be activated, thus

 

disabling the remote control unit operations. If the action indicator remains

 

continuously lighted, remove any object sitting on the touch sensor panel.

 

 

The front panel display

• If the display mode is set to Auto Display, the display will automatically turn off

and indicators do not

if no operation is performed for a period of one minute. Try performing an

appear.

operation.

 

 

Motion sensor not

• The motion sensor is on the front of the unit. Make sure you are within 2.5 m and

working.

40° of the sensor.

 

• Since the motion sensor uses infrared rays, it may not work correctly if placed in

 

direct sunlight or close to heat source.

 

• Minimum unit height must be 25 cm or above from ground level. The sensor will

 

not work properly when located at ground level.

 

• Motion sensor will not work if placed in a fully sealed cabinet (include glass /

 

clear cabinet).

 

 

English Deutsch Français Italiano Nederlands Español

61

En

Page 61
Image 61
Pioneer SX-LX03 manual Additional information, Problem, Remedy