Pioneer SX-LX03 Tuner, HDMI connection, Front panel display messages, Symptom, Message, Problem

11Additional information

Tuner

Problem	Remedy
Considerable noise in	• Connect the AM antenna (see Basic connections on page 26) and adjust the
radio broadcasts.	direction and position for best reception. You may also connect an additional
	internal or external AM antenna (refer to Connecting external antennas on
	page 49).
	• Fully extend the FM wire antenna, position for best reception, and secure to a
	wall. You may also connect an outdoor FM antenna (see Connecting external
	antennas on page 49).
	• Turn off other equipment that may be causing the noise or move it further away.
Auto tuning does not	• The radio signal is weak. Auto tuning will only detect radio stations with a good
pick up some stations.	signal. For more sensitive tuning, connect an outdoor antenna.

HDMI connection

Symptom	Remedy
No picture or sound.	• This unit is HDCP-compatible. Check that the components you are connecting
	are also HDCP-compatible.
	• Depending on the connected source component, it’s possible that it will not
	work with this unit (even if it is HDCP-compatible).
	• If the problem still persists when connecting your HDMI component directly to
	your monitor, please consult the component or monitor manual or contact the
	manufacturer for support.
No sound, or sound	• Check that the HDMI Audio is set to AMP.
suddenly ceases.	• If the component is a DVI device, use a separate connection for the audio.
	• Check the audio output settings of the source component.
HDMI Control does not	• Verify that the HDMI cable is firmly connected.
function.	• Make sure that this unit’s HDMI Control mode is set to Control On (page 55).
	• Check whether the connected component supports HDMI Control or not. For
	more information refer to the operating manual of your Flat Screen TV, DVD player,
	Blu-ray disc player, etc.
	• This unit does not guarantee HDMI Control-compatible components other than
	those made by Pioneer.

Front panel display messages

Message	Description
192kHz PCM	An operation is prohibited because the source is 176.4 kHz/192 kHz PCM.
2ch Only	An operation is prohibited because it is only applicable to 2 channel sources, while
	the current source is a multichannel source.
96kHz PCM	An operation is prohibited because the source is 88.2 kHz/96 kHz PCM.

62

En