Pioneer SX-LX03 Additional information, Problem, Check, Remedy, Is Audio Output Mode properly

Additional information 07

Problem	Check	Remedy
No picture is		With some content protected discs, it may not be possible to
displayed or picture is		output the video signals from the VIDEO output terminals,
not output in high		the S-VIDEOoutput terminal or the COMPONENT VIDEO
definition when		output terminals. In this case, connect using an HDMI cable
playing BDs.		(page 76).
No sound is output.	Is the disc played back in slow	No sound is output during slow motion play and forward and
Sound is disturbed.	motion?	reverse scanning.
	Is the disc played back in fast
	forward or fast reverse?
	Is the disc scratched?	The sound may not be output if the disc is scratched.
	Is the disc dirty?	Clean the disc (see the Blu-ray disc player’s operating
		instructions).
	Is the player properly connected	• Check that you connect the player to the audio output
	to the other components (AV	terminals of a different component, etc.
	receiver or amplifier, etc.)?	• Check that you connect the player to the PHONO input
		terminals of the AV receiver or amplifier, etc.
	Are the audio cables properly	Insert the cables firmly and all the way in.
	connected?
	Is the audio cable damaged?	If the cable is damaged, replace it with a new one.
	Is Audio Output Mode properly	If Audio Output Mode is set to Multi-channel, the audio
	set?	signals may not be output properly from the AUDIO OUT (2
		ch) terminals (page 109). Set Audio Output Mode to 2
		Channel.
	Are the speakers properly set?	Set Speaker Setup properly (page 110).
		For some BDs, audio signals are only output from the
		DIGITAL OUT (OPTICAL) terminal or the HDMI OUT
		terminal.

125

En