Pioneer SX-LX03 manual Additional information, Problem, Check, Remedy, 4:3 Standard page

07 Additional information

Problem

No picture is displayed or the picture is not displayed properly.

Check	Remedy
Is the video cable properly	Insert the cable firmly and all the way in.
connected?
Is the video cable damaged?	If the cable is damaged, replace it with a new one.
Is the input setting on the	Read the operating instructions of the connected
connected TV or AV receiver or	components and switch to the proper input.
amplifier right?

	Are the terminals for outputting	Press VIDEO SELECT to switch the terminal from which the
	video signals properly set?	video signals are output.
	Is the output video resolution	Depending on the player’s output video resolution, the
	properly set?	picture may not be displayed at all or displayed properly. Use
		OUTPUT RESOLUTION to switch to a resolution at which
		the picture is displayed properly (page 87).
	Is the player connected with an	Press  STOP while pressing  PLAY on the player’s front
	HDMI cable other than a High	panel to restore the video outputs to the factory default
	Speed HDMI™ cable (with a	settings. After this, use the Setup Navigator to reset the
	Standard HDMI™ cable)?	player.
		There are some BDs for which the picture will only be output
		when connected by HDMI cable.
	Does the connected TV support	If the picture is not displayed when playing a disc with a
	the frame rate of the video signal	frame rate that is not supported, the picture will not be
	being output by the player?	displayed even when playback is stopped. In this case, use
		the procedure below to switch the frame rate of the video
		signals output from the player. Eject the disc and close the
		disc tray. Then, press  OPEN/CLOSE while pressing
		 PLAY on the player’s front panel to switch to a frame rate
		supported by the connected TV.
	Is NTSC on PAL TV properly set?	Set NTSC on PAL TV properly (page 109).
Picture is stretched.	Is the TV’s aspect ratio properly	Read the TV’s operating instructions and set the TV’s aspect
Aspect ratio cannot	set?	ratio properly.
be switched.
	Is 4:3 Video Out properly set?	• Set 4:3 Video Out properly (page 108).
		• When video signals with a resolution of 1080/50i, 1080/
		50p, 720/50p, 1080/24p, 1080/60i, 1080/60p or 720/60p are
		being output from the HDMI OUT terminal or the
		COMPONENT VIDEO output terminals, they may be output
		with an aspect ratio of 16:9 even if TV Aspect Ratio is set to
		4:3 (Standard) (page 87).
Sound and picture are	Is Output Terminal Priority	Set Output Terminal Priority properly (pages 83 and 119).
not synchronized.	properly set?

Picture is disturbed during playback. Picture is dark.

•This player supports Macrovision analog copy protection technology. With some TVs (such as with built-in video deck), the picture will not be displayed properly when the copy protected DVD title is played. This is not a malfunction.

•If the player and TV are connected via a DVD recorder/ video deck, etc., the picture will not be displayed properly due to analog copy protection. Connect the player and TV directly.

124

En