Polycom V500 Configuring IP Network Support, Specifying H.323 Settings, To specify H.323 settings

Administrator’s Guide for the V500 System

Configuring IP Network Support

Use the following sections to configure the system so that you can place and receive video calls using IP on your LAN or WAN:

❑H.323 Settings, including Gatekeeper and Gateway

❑SIP Settings

❑Quality of Service

❑Firewall or NAT

Specifying H.323 Settings

If your network uses a gatekeeper, the system can automatically register its H.323 name and extension. This allows others to call the system by entering the H.323 name or extension instead of the IP address.

To specify H.323 settings:

1.Go to System > Admin Settings > Network > IP > H.323 Settings.

2.Configure these settings:

Setting	Description
Enable IP H.323	Specifies whether to allow IP dialing.
Display H.323	Lets you place a gateway call by entering the H.323 extension
Extension	separately from the gateway ID.
	If you do not check this box, you can make gateway calls by
	entering the call information in this format:
	gateway ID + TCS4 delimiter + extension
	Check with your network provider to determine your TCS4
	delimiter.
H.323 Name	Specifies the name that gatekeepers and gateways use to identify
	this system. You can make point-to-point calls using H.323 names
	if both systems are registered to a gatekeeper.
	The H.323 Name is the same as the System Name, unless you
	change it. Your dial plan may define the names you can use.
H.323 Extension	Lets you place point-to-point calls using the extension if both
(E.164)	systems are registered with a gatekeeper.
	The default H.323 Extension is based on the system serial
	number, but it can be changed. Your dial plan may define the
	extensions you can use.

3 - 6 www.polycom.com/videodocumentation