String with washer. | Tie a string to a washer (D) and feed the washer through the |
| lower side bracket hole in the right upright support. As the |
| washer falls to the floor, leave the upper end of the string |
| hanging out the side bracket hole. Remove the washer from the |
| other end of the string. |
| Remove any tape or wire ties that secure the display cable. |
| Unwrap the cable and remove the kinks. |
| Ask your assistant to hold the display console above the |
| upright supports while you feed the cable through the right |
| upright support. Make sure the cable connector rests on the |
| floor at the base of the upright support. |
| Lower the display console, align, and secure it to the upright |
| supports using six buttonhead screws (C) and six washers (D). |
| Finger tighten. |
| Important: Do not wrench tighten the screws until the unit |
| has been fully assembled. Make sure the fasteners do not |
| pinch the cable. Cables damaged by improper installation will |
| not be covered by the Precor Limited Warranty. |
| Tie the string to the cable connector. Pull the cable through the |
| side bracket hole in the base frame. Remove the string and |
| then, connect the cable to its receptacle. |
| Note: An audible click is heard when the cable is properly |
| attached. Place excess cable inside the upright support. |
M9.57 | 5 |