PYLE Audio DVR-940HX-S manual Rgb

The Initial Setup menu			16
Setting	Options	Explanation
Channel Swapping	Next Screen	Proceed to the next screen to swap channel
		assignments of different presets so that you can
		group together presets that naturally go together.
		Select two presets to swap then press ENTER.
Video In/Out
Input Colour	Next Screen	Proceed to the next screen to set the input colour
System		system for the external input and the built-in TV
		tuner. Use the Smart Jog (DVR-940HX-S)or
		PREV/	NEXT (DVR-545HX-S)or INPUT SELECT
		buttons to change the preset or external input. On
		the default Auto setting the recorder can generally
		correctly detect whether the input signal is PAL,
		SECAM, 3.58 NTSC or PAL-60, but in some cases you
		may have to set it manually if the picture is displayed
		incorrectly.

•Input Colour System cannot be set when the recorder is in D.TV mode.

•See also About the input colour system on page 151 for more information on this setting.

Component Video Interlace •		Select if your monitor/TV is not compatible with
Out		progressive-scan video.
	Progressive	Select if your monitor/TV is progressive-scan
		compatible. Check the operating instructions that
		came with your monitor/TV if you’re not sure.

For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than RGB. If your TV is incompatible with progressive scan video and you select Progressive, you will not be able to see any picture at all. In this case, press ONE TOUCH COPY while holding down the (STOP) button on the front panel to switch to Interlace (this also switches Screen Resolution on page 148 to the default setting).

When an HDMI device is connected and Video Priority Mode is set to HDMI, the Component Video Out setting is automatically set to Interlace.

AV1 Out	Video •	Sets the AV1(RGB)-TVSCART output to standard
		composite video (compatible with all TVs).
	S-Video	Sets the AV1(RGB)-TVSCART output to S-video.
		Recommended if you are using a long SCART cable.
	RGB	Sets the AV1(RGB)-TVSCART output to RGB. Good
		quality but check your TV for compatibility. Note that
		on this setting signals from the built-in tuner and
		from external inputs is not output when the recorder
		is in TV mode.

If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on page 167).

The Component Video Out setting (see above) has no effect when AV1 Out is set to RGB.

141

En