PYLE Audio DVR-940HX-S manual Audio Output Auto, Video Priority Mode Hdmi, Component

The Initial Setup menu		16
Setting	Options	Explanation
Audio Output	Auto •	Dolby Digital, MPEG and DTS sources are output as
		a bitstream signal. However, depending on the
		Audio Out setting, number of audio channels, and
		the HDMI-connected device, Linear PCM audio may
		be output.
	PCM	All audio signals are converted to Linear PCM
		(except DTS).
	Bitstream Priority	Select if the connected device is compatible with bit-
		stream audio.
This setting is not available when a DVI device is connected.
Video Priority Mode HDMI •		Select for high quality picture output on a connected
		HDMI display. However, on this setting the YNR and
		Detail picture quality settings are not effective for
		analog video, and component video will be set to
		interlaced.
	Component	Select if you want the YNR and Detail picture quality
		settings to be effective for both HDMI and analog
		video output, or if Component Video Out is set to
		Progressive while an HDMI display is connected
		(page 141).
		When watching video on an HDMI display, use the
		HDMI setting.
Options
On Screen Display	On •	The recorder displays operation displays (Stop, Play,
		etc.) on-screen.
	Off	Switches off the on-screen operation displays.
Front Panel Display	On •	The time is shown in the front panel display when the
		recorder is in standby.
	Off	The front panel display is switched off in standby
		(although it still lights dimly when setting a timer
		recording).
Remote Control	Recorder 1–3	If you are using more than one recorder in the same
Mode	(default: Recorder 1)	room, set them to different IDs. This setting sets the
		recorder ID; to change the remote controller ID,
		press and hold RETURN/EXIT then press 1, 2 or 3 to
		set. The remote will only control a recorder with the
		same ID.

149

En