PYLE Audio DVR-940HX-S manual DV video setting, About DV, There’s a picture, but no sound

09Playing and recording from a DV camcorder

Frequently Asked Questions

•I can’t get my DV camcorder to work with the recorder!

Check that the DV cable is properly connected. Also make sure that what you’re trying to record is not copy- protected.

If it still doesn’t work, try switching off the camcorder then switch back on.

•There’s a picture, but no sound!

Try switching the DV Input setting (see DV Input on page 143) between Stereo 1 and Stereo 2.1

DV video setting

Use this setting to adjust the picture quality of the incoming video from the DV device connected to the DV jack of this recorder.

•HOME MENU Select ‘DV’, then ‘DV Video Setting’ from the Home Menu.

For detailed information on this setting, see Setting the picture quality for TV and external inputs on page 133.

About DV

Using DV, also known as i.LINK or IEEE 1394- 1995, you can connect a DV camcorder to this recorder using a DV cable for input of audio, video, data and control signals.

“i.LINK” and the “i.LINK” logo are trademarks.

•This recorder is only compatible with DV- format (DVC-SD) camcorders. Digital satellite receivers and Digital VHS video recorders are not compatible.

•You cannot connect more than one DV camcorder at a time to this recorder.

•You cannot control this recorder from external equipment connected via the DV IN jack.

•It may not always be possible to control the connected camcorder via the DV IN jack.

•DV camcorders can usually record audio as stereo 16-bit / 48 kHz, or twin stereo tracks of 12-bit / 32 kHz. This recorder can only record one stereo audio track. Set the DV Input setting as required (see DV Input on page 143).

•Audio input to the DV IN jack should be 32 kHz or 48 kHz (not 44.1 kHz).

•Picture disturbance in the recording may occur if the source component pauses playback or plays an unrecorded section of tape, or if the power fails in the source component, or the DV cable is disconnected.

•The DV IN jack is an input only. There is no output functionality.

Note

961 If the audio subcode on the DV tape cannot be read correctly, the audio type will not switch automatically. You

En can switch the audio manually from the External Audio setting (page 142).