PYLE Audio DVR-940HX-S manual Incorrect Cprm information, Repairing disc, Repairing the HDD

17Additional information

Message	Explanation/Action
• Incorrect CPRM information.	The recorder could not read the CPRM
	information. The recorder may be damaged—
	please consult a Pioneer Service Center.
• Repairing disc.	During recording, the power was cut. This display
• Repairing the HDD.	appears when the power is restored.
• Could not repair the disc.	The recorder was unable to repair the disc after a
	power cut. The contents of the recording will be
	lost.

•Overheating has stopped operation. Press DISPLAY to clear message.

The internal temperature of the recorder has exceeded the operating limit. If this message reappears, please contact a Pioneer authorized service center.

•HDD optimization is recommended. This can be done using Disc Setup.

The HDD should be optimized (basically, HDD housekeeping) to maintain playback and recording performance.

•Please perform HDD optimization. The HDD is in more urgent need of optimization in

This can be done using Disc Setup.	order to maintain performance.
• The HDD has not been sufficiently	If this message appears repeatedly after
optimized. Please optimize again.	optimizing the HDD it is likely that there is not
	enough free space on the HDD for optimization to
	complete properly. Please erase some titles from
	the HDD and optimize again.

•This channel’s TV system is different from the recorder’s setting.

The TV system (PAL, NTSC, etc.) of the current channel is different from the TV system settings of this recorder.

•Recording failed due to a TV system The timer recording failed because the TV system

mismatch. Press DISPLAY to clear	of the channel set for recording was different from
message.	the setting of the recorder.

•Playback has stopped because the TV During recording or timer recording standby, the system is different than the recording. TV System (PAL, NTSC, etc.) of the playback video

changed, causing playback to stop automatically.

•You are not allowed to watch this Conditional Access Program.

A CA module or smart card (obtained from your service provider) is required to watch the selected program. Insert the supplied module or card into the Common Interface card slot on the rear of the recorder (page 15).

•There is no DV input or the input sig- nal is unrecordable.

No signal was detected at the DV IN jack. This may appear if a blank section of DV tape is playing in the connected camcorder.

162

En