Q
2 – Operations and Administration
2.2.6.1.1
Target Configuration Window Field Descriptions
The following are descriptions for each field in the Target Configuration window: SNMP Target Addresses:
❥Address Name
Specifies a unique,
❥Transport Domain
Specifies the transport type of the address contained in the snmpTargetAddrTAddress object (e.g., 1.3.6.1.6.1.1 = udp, 1.3.6.1.4.1.1977.200.1 = tcp).
❥Transport Address
Specifies the IP address in dotted decimal format.
NOTE: The combination of the Transport Domain and the Transport Address determines the trap destination.
❥Port
Specifies the TCP or UDP port that the SNMP trap is sent.
❥Timeout
Specifies the time (in milliseconds) that the trap sender waits on a response before
❥Retry Count
Specifies the number of attempts to be made to send the trap after a timeout condition occurs.
NOTE: Timeout and Retry Count are SNMP v2.c and above. Not applicable for v1 traps.
❥Tag List
Specifies which traps should be sent to this particular destination.
NOTE: RFC2233 specifies the link up/down traps. Including RFC2233 in the Tag
List specifies that the trap receiver will get link up/down traps.
❥Parameters
Specifies a mapping to an entry in the SNMP Target Parameters table, determining the version of SNMP to use.
❥Storage Type
|
