Appendix D CM-2 Management Commands LRS-24 Installation and Operation Manual
D-6 Defining LRS-24 And CM-2 SNMP Agent Parameters
Table D-2. DEF HUB Command Fields (Cont.)
Field Name Description Options
HUB LOCATION IS Concise description of the hub location Maximum 20 alphanumeric
characters
CONTACT PERSON IS Name of person to be notified in case of problems
/contact information
Maximum 20 alphanumeric
characters
CM CARD SOFTWARE
VERSION
Software version of CM-2 module
MAIN CARD HW REV Hardware version of CM-2 module
INTERFACE CARD HW REV Hardware version of CM-2 interface module
TIME Time of internal CM-2 real-time clock (the time is
correct for the instant the command has been
received by the CM-2 module).
To change the time, type the correct time
according to the format: hh:mm:ss.
Set the time at least one minute beyond the current
time, so you will be able to press <Enter> at the
correct instant after completing all the fields on the
data form.
Display format is
hours:minutes:seconds.
DATE Date of internal CM-2 real-time clock.
To change the date, type the correct date
according to the format: YYYY-MM-DD. When
done, press <Enter> to move to the next field.
Display format is
year:month:day.
IP ADDRESS IP address assigned to CM-2 module, in dotted-
quad format.
When assigning the IP address, remember that the
following 12 IP addresses must be reserved for I/O
modules (the first address will be associated with
I/O slot 1, and the last address with slot 12).
Four groups of digits in the
range of 0 through 255,
separated by periods
IP MASK Subnet mask corresponding to the IP addresses
used by the CM-2 module
Dotted-quad format.
READ COMMUNITY Name of SNMP community that has read-only
authorization (the CM-2 SNMP agent will accept
only getRequest and getNextRequest commands
from management stations using that community).
Up to seven alphanumeric
characters
READ/WRITE COMMUNITY Name of SNMP community that has read-write
authorization (the CM-2 SNMP agent will also
accept setRequest commands from management
stations using that community).
Up to seven alphanumeric
characters
TRAP COMMUNITY Name of SNMP community to which the CM-2
SNMP agent will send traps
Up to seven alphanumeric
characters
DEFAULT GATEWAY IP address of default gateway to be used by CM-2
module to contact a management station located
on a different IP network.
If the CM-2 module and the management station
are located on the IP same network, enter
0.0.0.0.
Dotted-quad format
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com