RAD Data comm LRS-24 operation manual Index of Commands, Errors Execution, Command Function/Action

In general, if an error is detected during command evaluation, the command is not executed. Instead, the module will send an error message to the terminal. The correct command must then be sent again.

Chapter 4 Management via the CM-2 Module LRS-24Installation and Operation Manual

Scrolling Values When a field has a limited range of values, the available values are displayed by scrolling. To scroll, bring the cursor to the desired field, and then press <F> or <U> to scroll forward, press <B> or <D> to scroll backward. Press <+> or <–>to scroll to the next or previous command, for up to 10 commands.

Command evaluation Starts only when the <Enter> key is pressed.

Errors

	Execution	The command is executed only after it is validated.
Index of Commands
	Table 4-1lists the set of commands recognized by the CM-2 module in
	alphabetical order.
	In addition to the commands listed in Table 4-1, the CM-2 module will recognize
	commands addressed to I/O modules that can control directly the supervision
	terminal. For information on the commands available for any particular I/O
	module, refer to the Installation and Operation Manuals of that module.
	Table 4-1. Terminal Command Set Index for CM-2 Module
Command	Function/Action
DEF CALL	Defines parameters for the dial-up modem.
DEF CRD	Defines modem type per slot and connection to remote site
DEF DWL	Defines operational parameters or command for Download Software version
DEF HUB	Defines parameters of CM-2 SNMP agent and general LRS-24 parameters
DEF MNG	Defines list of management stations receiving traps generated by CM-2 module
DEF OPR	Defines general management parameters of an I/O module (applicable only to modules which do not
	support direct management by terminal or SNMP)
DEF PRM	Defines basic operational parameters of an I/O module (applicable only to modules which do not support
	direct management by terminal or SNMP)
DEF TRM	Defines supervision terminal type
DEF TST	Performs test on an I/O module (applicable only to modules which do not support direct management by
	terminal or SNMP)
DSP ALM	Displays general alarm status of LRS-24
DSP ALT	Displays module alarm status (applicable only to modules which do not support direct management by
	terminal or SNMP)
DSP HUB	Displays modules installed in LRS-24
DEF CFG	Displays Auto Config screen
DEF MDL	Downloads to the modem
DSP LOG	Displays list of alarms for CM-2 module, or for a selected I/O module (applicable only to modules which
	do not support direct management by terminal or SNMP)
DSP STT	Displays I/O module status and diagnostics (applicable only to modules which do not support direct
	management by terminal or SNMP)
4-12	CM-2 Supervision Terminal Language

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com