RAD Data comm LRS-24 operation manual Table D-3 DEF HUB Command Fields, Bootp ON/OFF

LRS-24Installation and Operation ManualAppendix D CM-2 Management Commands

	Table D-3 DEF HUB Command Fields (Cont.)
Field Name	Description	Options
BURN IN MAC ADDRESS	Fctory MAC address used by BOOTP server to
	declare the IP address of the CM-2.

BOOTP ON/OFF	Toggle to select BOOTP.
	To maintain backwards compatibility (with any
	LRS-12 version), set BOOTP ON/OFF to OFF.
	Otherwise, BOOTP ON/OFF should be set ON.
	In either case, BOOTP ON/OFF should be set to
	OFF while setting the IP address.

ON– use BOOTP OFF–no BOOTP.

Default value: OFF

BOOTP TIME OUT	Maximum waiting time for a BOOTP response	1, 2, 3, 4, 6, 8, 10, 15, 20
		seconds.
		Default value: 10 seconds
BOOTP RETRIES	Number of times to retry sending a request for the	3, 4, 5, 10, 15, 20, 25, 30 times.
	BOOTP server	Default value: 30 times
HUB IP MODE		SINGLE – only one IP address.
		(The LRS-24 address is the CM-2
		address.). CM-2 receives SMOD
		message and transfers to it to the
		SMOD modem after adjusting
		the IP. The IP is resolved from
		the community field. In this
		mode, ping and Telnet cannot
		be used directly on an SMOD;
		only the CM-2 IP address is
		relevant.
		MULTIPLE – normal mode.
		Every SMOD has its own IP
		address and the CM-2 does not
		interfere at the IP level. Every
		SMOD IP is calculated by
		adding the CM-2 IP address and
		the SMOD slot number.
SERIAL LINE PROTOCOL	SLIP Protocol	RS232 – terminal
STATION CLOCK	Set clock for station	Internal
		External – Square
		Ext-AMI

Defining LRS-24 And CM-2 SNMP Agent Parameters D-7

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com