RAD Data comm LRS-24 Table D-6. Terminal Types, To select a terminal, Define Terminal Type

Appendix D CM-2 Management Commands LRS-24Installation and Operation Manual

•Move cursor to the right by one position.

The terminal types supported by the CM-2 module are: VT-52, VT-100, TV-920, FREEDOM-100, FREEDOM-110, FREEDOM-220, and terminals that are compatible with these types. Selecting an incorrect terminal type may prevent correct display of data entry forms on the terminal.

Table D-6shows the codes used by the supported terminals.

Table D-6. Terminal Types

Function			Terminal Type
	TV- 920	VT-52	VT-100	Freedom-100	Freedom-220
				Freedom-110
Clear Screen	1B2A0000	N/A	1B5B324A	1B2A0000	1B5B324A
Cursor Home	1E000000	1B480000	1B5B4800	1E000000	1B5B4800
Cursor Right	0C000000	1B430000	1B5B3143	0C000000	1B5B0143

This command is always addressed to the CM-2 module. Therefore the node address must always be 13.

Format

NODE 13 DEF TRM

Procedure

➤To configure the CM-2 module for the desired terminal:

• Type: NODE 13 DEF TRM <Enter>.

The terminal selection form appears. A typical form is shown in

Figure D-20.

DEFINE TERMINAL TYPE

1.TV920

2.VT52

3.VT100

4.FREEDOM 100/110

5.FREEDOM 200 DEFAULT TYPE IS VT 100 ENTER TERMINAL TYPE No. -->

Figure D-20. Define Terminal Type Screen

➤To select a terminal:

1.Type the corresponding number.

2.If the resulting display is not correct, try selecting another terminal.

D-22 Defining Supervision Terminal Type

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com