Chapter 4 Management via the CM-2 Module

LRS-24Installation and Operation Manual

 

 

Changing the Password

The factory set password is radlrs.

To change the password:

1.Type NODE 13 DEF PWD <Enter>.

The Password Menu Screen appears (see Figure 4-5).

PASSWORD MENU

 

 

 

 

 

 

 

 

 

Enter new password

: radlrs

Enable password

: NO

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure 4-5. Password Menu Screen

2.Type the new password (up to 27 characters, for terminal and TELNET).

3.If you forget the password, switch JP15 on CM-2 to BYPASS.

BYPASS PASSWORD

JP15

Figure 4-6. JP15 Settings

Preliminary Configuration

To perform preliminary configuration:

1.Press the <Enter> key several times to see the working prompt of LRS-24, which is by default CM2>.

2.Define the terminal type you are using by entering the command

NODE 13 DEF TRM.

3.Use the command NODE 13 DEF HUB to define the parameters of the CM-2 module, and the general parameters of LRS-24 that you are configuring.

4.Use the command NODE 13 DEF MNG to define the management stations to which to send traps generated by the CM-2 module.

5.Define the modem cards by entering NODE 13 DEF CRD to define the modules installed in the LRS-24 hub.

Refer to Chapter 4 for detailed command syntax and protocol.

Configuring Individual Modules

After completing the preliminary configuration, begin configuration of the individual I/O modules. Before starting this activity, it is recommended to use the NODE 13 DSP HUB command to identify the modules installed in LRS-24, since configuration procedures depend on the module management type (IMOD or SMOD), and model.

4-14 Supervision Terminal Operating Instructions

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610

www.bestdatasource.com

Page 78
Image 78
RAD Data comm LRS-24 Changing the Password, Factory set password is radlrs, Password Menu Screen appears see Figure