Appendix D CM-2 Management CommandsLRS-24Installation and Operation Manual

 

 

Table D-1. DEF CALL Fields (Cont.)

 

 

 

Field Name

Description

Options

ALT NUM MODE

Enables dialing the alternate number.

NO – Dialing the alternate number is disabled. CM-2 stops the call attempt after the NUM OF RETRIES call attempts on the primary number have failed.

YES – Use of the alternate number is enabled. The alternate number is dialed after the NUM OF RETRIES call attempts on the primary number have failed.

NA – Not available, same as the value NO

ALT NUM

Alternate phone number

 

 

Returning to Terminal Mode

To return to the terminal mode while the Dial Modem Status is Active:

1.Disconnect the modem from the terminal port.

2.Wait for one minute.

The Dial Modem Status automatically becomes INACTIVE.

D.2 Defining LRS-24 And CM-2 SNMP Agent Parameters

Purpose

Defines or modifies the parameters of the CM-2 module (including the parameters of the SNMP agent), and the general LRS-24 parameters. This command is always addressed to the CM-2 module. Therefore the node address must always be 13.

The SNMP agent parameters must be defined before it is possible to manage the LRS-24 using SNMP-based management stations. Refer to Appendix C for additional information related to IP and SNMP parameters.

Format

NODE 13 DEF HUB

Procedure

To define the LRS-24 and SNMP agent parameters:

1.Type: NODE 13 DEF HUB<Enter>.

The first line of the data entry form (name entry form) appears. 2. Enter name of hub. Press <Enter> to store the data.

D-4 Defining LRS-24 And CM-2 SNMP Agent Parameters

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610

www.bestdatasource.com

Page 106
Image 106
RAD Data comm operation manual Defining LRS-24 And CM-2 Snmp Agent Parameters, Returning to Terminal Mode