Edit mode (EDIT)
13.To specify “2” for the upper bits, press the [2] key. The display will indicate “2BL”.
14.Confirm what’s indicated and press [ENTER].
15.In the same way, enter bytes 8.
16.Since the ninth byte is the data area, press the [DATA] key. The display will indicate “DT0.”
17.Confirm what’s indicated and press [ENTER].
18.Since the ten byte will contain the checksum, press the [CHECKSUM] key to specify the location at which the checksum will be input.
The display will blink “CS1” (Checksum Type 1).
19.Confirm what’s indicated and press [ENTER].
20.Press the [F] and then [7] keys to input the ending status “F7.”
21.Confirm what’s indicated and press [ENTER].
22.Next, specify an upper limit value of “58” for the data area.
23.Press [ENTER].
24.Specify a lower limit value of “40” for the data area.
25.Press [ENTER].
26.Specify the output port.
(➔“Specifying the port” (p. 159))
27.If you are making an assignment for a button, specify the button mode. (➔“Specifying the button mode” (p. 158))
The GS Bend Pitch Control message has been assigned.
145