Installing & Setting Up the Driver (Macintosh)

3

4

Double-click the PCR Driver-E Installer icon (found in the Driver E (Mac OS 9, 8) folder of the CD-ROM) to start up the installer.

Verify the Install Location, and click [Install].

fig.3-2_40

5

6

If a message like the following is displayed, click [Continue].

The other currently running applications will exit, and installation will continue.

A dialog box will indicate Installation completed.

Click [Restart] to restart your Macintosh.

■Setting the driver

OMS settings

1

2

fig.3-3

3

fig.3-4

4

Use the USB cable to connect the PCR-30/50/80to your computer.

1.With the power switch turned OFF, connect the AC adaptor to the

PCR-30/50/80.

2.Connect the AC adaptor to an electrical outlet.

3.Use the USB cable to connect the PCR-30/50/80to your computer.

Set the PCR-30/50/80’s power switch to the ON position.

From the CD-ROM, drag the Driver E (Mac OS 9, 8) - OMS Setting folder to the hard disk of your Macintosh to copy it.

In the Opcode-OMS Application folder where you installed OMS, double-click OMS Setup to start it up.

Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.

26