Roland PCR-30, PCR-50, PCR-80 Installing & Setting Up the Driver (Macintosh), Mac OS 9/8 users, Use either OMS or FreeMIDI as the MIDI driver

Installing & Setting Up the Driver (Macintosh)

The installation procedure will differ depending on your system.
Please proceed to one of the following sections, depending on the system you use.
•	Mac OS 9/8 users .................................................	(p. 25)
•	Mac OS X users .....................................................	(p. 31)

Mac OS 9/8 users
■ Installing the driver
Use either OMS or FreeMIDI as the MIDI driver.
	OMS can be found in the
The included PCR driver is an add-on module for using the PCR-30/50/80
	OMS 2.3.8 E folder within
with OMS or FreeMIDI.
	the OMS folder of the
* Either OMS or FreeMIDI must be installed in your Macintosh, as appropriate	CD-ROM. If you would
	like to know more about
for the sequencer software you are using.	OMS, refer to
* Disconnect the PCR-30/50/80 from the Macintosh before you perform the installation.	OMS_2.0E_Mac.pdf
	which can be found in
	the same folder.

English

Deutsch

Français

1

2

If a PCR-30/50/80 is already connected to your Macintosh when you install the driver, a message like the following will appear when the Macintosh is started up. Perform the steps described below as appropriate for the message that is displayed.

If the screen indicates:

“Driver required for USB device ‘unknown device’ is not available. Search for driver

on the Internet?” ➔ click [Cancel].

If the screen indicates:

“Software required for using device ‘unknown device’ cannot be found. Please refer to the manual included with the device, and install the necessary software”.

➔click [OK].

Use the following procedure to install the PCR-30/50/80 driver.

Exit all currently running software (applications).

If you are using a virus checker or similar software, be sure to exit this as well.

Prepare the CD-ROM.

Insert the CD-ROM into the CD-ROM drive.

Italiano

Español

25