Installing & Setting Up the Driver (Macintosh)

Cautions when using the PCR

Before you use your sequencer software, please note the following points.

*Connect the PCR-30/50/80 to your computer via a USB cable before you start up your sequencer or other software.

*Do not disconnect the USB cable from the PCR-30/50/80 while your sequencer or other software is running.

*Disconnect the USB cable from the PCR-30/50/80 only after you have quit your sequencer or other software.

*Leave the Sleep function of your Macintosh turned off.

*The PCR-30/50/80 will not work in the Classic environment of Mac OS X. Use the PCR when the Classic environment is not running.

■Setting the driver

1Use the USB cable to connect the PCR-30/50/80to your computer.

1.With the power switch turned OFF, connect the AC adaptor to the

PCR-30/50/80.

2.Connect the AC adaptor to an electrical outlet.

3.Use the USB cable to connect the PCR-30/50/80to your computer.

2Set the PCR-30/50/80’s power switch to the ON position.

3Make MIDI device settings on your sequencer software. For details on the

MIDI OUT/IN device to select, refer to “About the ports when using a USB connection” (p. 159).

This completes the series of steps needed to connect the PCR-30/50/80 to the Macintosh, install the MIDI driver, and make the driver settings.

For details on MIDI device

settings, refer to the

owner's manual for the

software you are using.

32