Roland PCR-30, PCR-50, PCR-80 If “File signature verification” is set to “Warn”, If “File signature verification” is set to “Block”

Installing & Setting Up the Driver (Windows)

Click the Windows Start button. From the menu that appears, select “Run...”.

Open the “Run...” dialog box.

fig.2-14_40

10In the dialog box that appears, input the following into the “Open” field, and click [OK].

	D:\Driver\USB_XP2K\SETUPINF.EXE
	* The drive name “D:” may be different for your system. Specify the drive name
	of your CD-ROM drive.
	11The SetupInf dialog box will appear.

		Once the connections have
		been completed, turn on
		been completed, turn on
	You are now ready to install the driver.	power to your various
	12Use the USB cable to connect the PCR-30/50/80to your computer.	devices in the order
		specified. By turning on
		devices in the wrong
		devices in the wrong
		order, you risk causing
	1. With the power switch turned OFF, connect the AC adaptor to the	malfunction and/or
	PCR-30/50/80.	damage to speakers and
	2. Connect the AC adaptor to an electrical outlet.	other devices.
	2. Connect the AC adaptor to an electrical outlet.
	3. Use the USB cable to connect the PCR-30/50/80to your computer.

		This unit is equipped with
	13Set the PCR-30/50/80’s power switch to the ON position.	This unit is equipped with
		a protection circuit. A brief
		interval (a few seconds)
		after power up is required
		before the unit will operate
		normally.

If the “File signature verification” setting was not set to “Ignore”, a “Digital Signature Not Found” dialog box will appear.

If “File signature verification” is set to “Warn”

1.Click [Yes].

2.Continue the installation.

If “File signature verification” is set to “Block”

1.Click [OK].

2.When the “Found New Hardware Wizard” appears, click [Finish].

3.Perform the installation as described in the “Troubleshooting” section on Device Manager shows “?”, “!”, or “USB Composite Device” (p. 172).

English

Deutsch

Français

Italiano

Español