Runco SP-50, SP-42, SP-60 manual Set-Up, Power, Off

Operation

VSize (Installer Adjust mode): Use the up- or down-arrow buttons ( , ) to highlight V Size. Then, press SET and use the right-arrow button ( ) to increase the height; use the left-arrow button ( ) to decrease it.

HSize (Installer Adjust mode): Use the up- or down-arrow buttons ( , ) to highlight H Size. Then, press SET and use the right-arrow button ( ) to increase the width; use the left-arrow button ( ) to decrease it.

Image Reset: To reset all screen settings for the current input to the default, Installer Adjust mode values, select Image Reset from the Screen menu. Then, press to highlight YES and press SET.

Color Temperature: To adjust the color temperature, select Color Temperature from the Set-Up menu. (Color temperature defines the “color of gray.”) Use the left- and/or right-arrow buttons to select LOW, MID-LOW, MIDDLE, MID-HIGH or HIGH. The default setting, MIDDLE, is appropriate for most situations. Higher settings produce a “bluer” picture; lower ones cause the image to appear more red.

Auto Off: When using the CinemaWall with a computer, set Auto Off to ON to have the CinemaWall go into standby mode when no source signal is present on the current input. (A warning message appears on-screen for approximately eight seconds before this occurs.) To return to normal operating mode from the Auto Off standby mode, select the input with the remote control or operate your computer.

When Auto Off is disabled (OFF), the CinemaWall remains in normal operating mode, regardless of the presence or absence of an input sync signal.

Note	1. If the computer is turned off or not properly connected to the
	CinemaWall, the system is set to the off state.

2.For instructions on using the computer's power management features, refer to the instructions for your computer.

The STANDBY/ON indicator at the front of the CinemaWall indicates the status of the power management function, as described in Table 4-2.

Table 4-2. Power Management Indications

Power	STANDBY/	Power		Turning the
management	ON	management	Description
				picture back on
mode	Indicator	operating status
ON	Solid	Not activated.	Horizontal and ver-	Picture already on.
	green		tical synchronizing
			signals are present
			from the com-
			puter.
OFF	Flashing	Activated.	Horizontal and/or	Press a key on the
	green		vertical synchroniz-	keyboard or move
			ing signals are not	the mouse. The
			present from the	picture reappears.
			computer.

Video NR: To apply Digital Noise Reduction (DNR) to the input signal, select Video NR from the Set-Up menu. Noise reduction is useful for improving the signal-to-noise ratio of video signals.

Set-Up

CINEMAWALL					INPUT 2
PICTURE		SCREEN	SET-UP	OPTION
		COLOR TEMP.	: MIDDLE
		AUTO OFF	: OFF
		VIDEO NR	: MIDDLE
		MPEG FILTER	: LOW
		CHROMA EE	: ON
		FILM MODE	: OFF
		COLOR SPACE	: RGB
		DVI SET UP
		SIGNAL	: 720p
SET	SET		MENU		EXIT

INSTALLER ADJUST					INPUT 1
PICTURE		SCREEN	SET-UP	OPTION
		BRT. ENHANCE	: OFF
		SUB VOLUME	: +20
SET	SET		MENU		EXIT

Runco CinemaWall SP-42/-50/-60 Owner’s Operating Manual 39