Runco SP-60, SP-42, SP-50 manual Option Installer Adjust Mode, Installer ADJ Input

Operation

Auto Function: The CinemaWall can automatically switch to Input 1 or Input 4 (Model SP-50/SP-60 only) when an image signal is detected at that input. To enable this feature, select Auto Function from the Option menu and set it to INPUT 1 (or INPUT 4, on a Model SP-50/SP-60).

After Auto Function triggers an input switch, when the Input 1 or Input 4 signal is no longer present, the input source reverts to the previously-selected input.

On the Model SP-42, Auto Function is supported on Input 1 only.

Note The input signal must be RGB with composite or separate sync; Auto Function will not work with sync-on-green RGB or component signals.

When Auto Function is active, selecting an input manually causes

Auto Function to be temporarily disabled. If you cycle power to the

CinemaWall, Auto Function becomes active again.

Program Timer (SP-42) / Screen Maint. (SP-50/SP-60):When in Installer Adjust mode, select Program Timer (SP-42) / Screen Maint. (SP-50/SP-60)from the Option menu to program the screen maintenance features of the CinemaWall to operate at regular intervals. This is useful for preventing image burn-in.

You can program the CinemaWall to switch inputs and/or replace the normal source signal with a white field, an inverse image or an “orbiting” image. You can specify a time of day and day of the week when you want this to take place.

To set up a screen maintenance program:

1.Press SET to select the DATE field for the first program. Press or to select one of the following:

•SUN, MON, TUE, WED, THU, FRI or SAT for a program that runs once only on the next occurrence of that day.

•* for a program that runs daily.

•*SUN, *MON, *TUE, *WED, *THU, *FRI or *SAT for a program that runs weekly on that day.

2.Press SET, then followed by SET again to set the program start time.

3.Press or to set the hour component of the start time.

4.Press , then or to set the minute component of the start time.

5.Press SET, then followed by SET again to set the program end time (repeat steps 3 and 4).

6.Press SET, then followed by SET again to specify an input associated with this program. Choose “–” to specify the input that was active when the CinemaWall was last powered off.

7.Press SET, then followed by SET again to select the PATTERN field for this program. Press or to select one of the following:

•Choose “–” to specify the function that was active when the CinemaWall was last powered off.

•Choose WHITE to display a white field.

•Choose INVERSE to display an inverse image.

•Choose ORBITER to display an “orbiting” image.

Option (Installer Adjust Mode)

INSTALLER ADJ.						INPUT 3
PICTURE		SCREEN	SET-UP		OPTION
		PROGRAM TIMER
		TEST PATTERN		: OFF
		SIDEBAR ADJ.
		BAUD RATE		: 9600BPS
		ID NUMBER		: ALL
SET	ENTER				MENU	EXIT

PROGRAM TIMER

DATE	ON	OFF	INPUT	PATTERN
*	10:00	– –:– –	–	–
*	20:00	– –:– –	–	WHITE
*	– –:– –	21:00	–	–
–	– –:– –	– –:– –	–	–
–	– –:– –	– –:– –	–	–
–	– –:– –	– –:– –	–	–
–	– –:– –	– –:– –	–	–
RETURN
SET	ENTER			MENU EXIT

Runco CinemaWall SP-42/-50/-60 Owner’s Operating Manual 43