4Programming 1999.9.15 12:43 PM 페이지55
PROGRAMMING SECTION | |
|
|
MMC 57 | CALL COST |
This MMC is used to program the unit cost of the metering pulse generated by the Central Office. If the MPD card is installed, it will detect the metering pulse provided by Central Exchange and determine the call cost by the number of metering pulses and unit cost programmed via this MMC. The unit cost is a four (4)digit number, and is measured in the minimum money denomination in the country of use.
PROCEDURE | LCD DISPLAY |
1. Press [TRANSFER] and dial 57 Display shows
2. Enter the
If you don't enter 4 digits, the existing data will not be changed.
3. Press [TRANSFER] to save and exit
DEFAULT DATA
UNIT COST : 0000
(The range of the CALL COST is 0001 ~ 9999)
RELATED MMC
NONE
MMC 60 | TOLL DENY TABLE/APPLY |
This MMC enables you to define which leading digit(s) in a dialing plan are to be restricted and which class(es) should be applied in this toll deny table. Each entry can define up to 11 digits.
PROCEDURE | LCD DISPLAY |
1. Press [TRANSFER] and dial 60
2. Press [MUTE] or [MESSAGE] select the search class (search class = NEW, ALL, B,C,D,E)
3. Press [VOLUME
4. Enter the dial number to be restricted and press [CALLBACK] to assign the toll restriction apply class And dial four(4) digits,
0 for NO 1 for YES
5. Press [TRANSFER] to save and exit
DEFAULT DATA
NONE
RELATED MMC
MMC 30 STATION TOLL CLASS
MMC 61 TOLL ALLOW TABLE/APPLY
MMC 65 ASSIGN WILD CHARACTER
