Samsung NX-308 Connecting Telephone Lines, Connecting Station Equipment, Safety Precautions

2INSTALL 1999.9.15 12:45 PM 페이지24

NX-SERIESHYBRID KEY SYSTEM INSTALLATION SECTION

5. CONNECTING TELEPHONE LINES

5.1 SAFETY PRECAUTIONS

To limit the risk of personal injury, always follow these precautions before connecting to TELCO circuits:

●Never install telephone wiring during a lightning storm.

●Never install telephone jacks in a wet location unless the jack is specifically designed for wet locations.

●Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

●Use caution when installing or modifying telephone lines.

5.2LOOP START LINES

●Using one pair twisted #24 AWG or #26 AWG jumper wire, cross-connect each loop start C.O. line to the trunk port.

●Refer to FIGURE 4-1 through 4-7 and 4-8.

6.CONNECTING STATION EQUIPMENT

Using one pair twisted #24 AWG or #26 AWG jumper wire, cross-connect each keyset/AOM or single-line telephone to the keyset port or SLI port of your choice.

6.1 CONNECTING KEYSET / AOM (FIGURE 6-1)

The NX-308 system has seven hybrid ports and the NX-1232 system has eight hybrid ports.Either a keyset or a single-line telephone may be connected to a hybrid port. Before connecting station equipment to a hybrid port, the switches on the Base Board must be set to keyset or SLT.

Each switch is composed of four sections, set to ON/ON/OFF/OFF to connect a keyset to the hybrid port.

ON

❶ ❷ ❸ ❹

OFF

Each numbered switch has four sections: ❶ ❷ ❸ ❹ .

To connect a keyset to a hybrid port, they are set to ON/ ON/ OFF/ OFF.

6.1.1 NX-308 - Related Switch Location (FIGURE 6-3)

To connect a keyset or AOM to station #2 to #8 of basic KSU, the related DIP switches should be set as follows: (Station #1 is a keyset-only station.)

2 - 20