Sanyo CHDX07263, CHDXR07263, CHDXR09663, CHDX09663 service manual Detailed Settings Function

2. Detailed Settings Function

W-2WAY ECO-i SYSTEM Remote Controller Functions

	Item code	Item	Description
	10	Unit type	Set when the indoor unit EEPROM memory is replaced during servicing.
	11	Indoor unit capacity
	12	System (outdoor unit)
		address	These are not set at the time of shipping from the factory.
	13	Indoor unit address	These must be set after installation if automatic address setting is not
			performed.
	14	Group address
		Cooling intake temperature	Shifts the intake temperature during cooling and dry operation.
	17		(Enabled only when the body thermostat is used.)
		shift
			Increase this value when it is difficult to turn the thermostat ON.
	18	Automatic stop time after	The time at which an indoor unit is automatically stopped after operation starts
		operation start	can be set in increments of 5 minutes.
			Use this setting to change the time for forced operation at installation or
	1b	Forced thermostat ON time	servicing from 5 minutes to 4 minutes.
			(Enabled only with PAC-i models.)
	1C	Cooling discharge	Shifts the set value for models which perform discharge temperature control.
		temperature shift
			(Discharge temperature control models: Floor discharge, wall built-in, direct
		Heating discharge
	1d		expansion coil outdoor air treatment, high-fresh)
		temperature shift
			“Auto heat/cool” selects the operating mode automatically based on the
		Temperature shift for	difference between the room temperature and the temperature set on the
	1E	cooling/heating change in	remote controller. This setting establishes a shift temperature for the heating/
		“auto heat/cool” mode	cooling temperature setting relative to the remote controller temperature
4			setting.

Cooling temperature setting

Remote controller temperature setting

Shift temperature

(+)

Shift temperature

(–)

Heating temperature setting

4 - 12