Sanyo CHDX09663, CHDXR07263, CHDXR09663 Setting mode 2 Operating procedure, List of Item Codes

6. Mode Settings

W-2WAY ECO-i SYSTEM Outdoor Unit Maintenance Remote Controller

NSetting mode 2 <Operating procedure>

ŒPress and hold the (CHECK) button, button, and button simultaneously for 4 seconds or longer.

Press the temperature setting and buttons to change the item code. The item codes and setting data are shown in the table below.

ŽPress the timer time and buttons to change the setting data.

To confirm the changed setting data, press the button.

(At this time, all displays stop blinking and remain lit.)

During this mode, “ ” is displayed, blinking. The display shows the set outdoor unit address “System XX-YY” (System XX = System address, YY =

Address at outdoor unit sub-bus), item code number (DN value in the table below), and the setting data (8 digits).

5

2

13

Fig. 7

(The setting data is displayed in 8 digits. The display changes between the first 4 digits (Fig. A ) and the last 4 digits (Fig. B ). When the first 4 digits are displayed, the top point of the colon is lit.)

To exit setting mode, press the (CHECK) button. Returns to the normal display mode.

3

A Display of first 4 digits B Display of last 4 digits

5

2

13

		<Refrigerant type> A and B are displayed alternately. (Example
		shows 0000 0410 (R410A).)
List of Item Codes
DN	Parameter		Description
81	Outdoor unit capacity		0 = Disabled 224 = 72 Type 280 = 96 Type

3 - 13