Sanyo CHDXR09663, CHDXR07263, CHDX09663, CHDX07263 service manual From previous

2. Detailed Settings Function

W-2WAY ECO-i SYSTEM Remote Controller Functions

(Continued from previous page)

	Item code	Item	Description
	3C	Heat exchanger temperature for	The heat exchanger temperature control point for prevention of cold air
		cold air discharge	discharge during heating operation can be changed.
	3d	Fan output switching	The indoor unit PCB optional output for the fan can be switched
			according to the purpose of use.
	3E	Drain pump delayed start time	The drain pump starts after the set time delay after cooling operation
			stops.
	40	Humidifier drain pump setting	This specifies the humidifier and drain pump setting.
	45	DC flap operation mode	Changes flap operation to draft reduction mode.
	46	DC flap swing mode	Selects the swing operation mode for the flap.
	5d	DC fan tap setting	Sets the DC fan tap according to the purpose of use.
			Change the settings data at the same time.
			Sets the humidifier output ON time for when the humidifier is operating.
	5E	Humidifier ON time	ON/OFF control is performed during humidifier operation.
			This setting therefore sets the ON time per 60-second interval.
		Stop at time set for OFF timer after	This setting enables a function that stops operation when the amount
	5F		of time set for the OFF timer has passed after remote controller
		operation starts
			operation was started.
	60	Timer function change prohibit	This function prohibits changes from being made to the remote
4			controller time setting.
	62	Smudging control	Smudging control is disabled when 0000 is set.

4 - 14