Configuring the SDC 8200 system
Aux Out 1
3Remote Conf.
Aux Out 1
Remote Conf. = OFF Press ENTER to Save
Configuring the audio outputs for remote conferencing
To prevent echo during remote conferencing:
Make sure that the two central units of the conference systems installed in separate rooms are connected correctly (see “Setting up remote conferences” on page 56).
From the central unit’s operating menu, choose
Choose the audio output “Aux Out 1”.
Choose “Remote Conf.”.
The current setting (“Remote Conf. = ON” or “Remote Conf. = OFF”) is shown on the display.
To prevent echo, choose “Remote Conf. = ON” (if not yet chosen) and press the ENTER key to save your setting.
9External Equalizer
External Equalizer
Status = OFF
Press ENTER to Save
Aux In 1
1Level
Aux In 1
Level = 00
Press ENTER to Save
Turning on/off an external equalizer
If you connect an external equalizer to the central unit, you have to acti- vate the equalizer via the central unit’s operating menu.
From the central unit’s operating menu, choose
Choose “Status”.
The current status (“ON” or “OFF”) is shown on the display.
Choose “Status = ON” and press the ENTER key to save your setting.
Note!
If the external equalizer is activated via the central unit’s operating menu, the central unit outputs the audio signals of the consoles’ micro- phones via the audio output and not via the consoles’
Adjusting the input level of an audio input
To adjust the input level of the two audio inputs:
From the central unit’s operating menu, choose
Choose the desired audio input.
Choose “Level”.
The current input level is shown on the display.
Adjust the input level and press the ENTER key to save your setting.
Adjusting the input sensitivity of an audio input
Depending on the strength of the audio signal delivered by the external audio source, adapt the input sensitivity as follows:
