Configuring the SDC 8200 system
Initialise Units
3Load Defaults
Initialise Units
1Manual Init
Manual Init
2Add Unit
Initialise Units
1Manual Init
Manual Init
3 Delete Unit
As soon as the initialization of a conference console is accepted by the central unit, the red signal light ring of the console goes off.
Press the ENTER key to save this configuration.
Loading the
If necessary, you can load the
Note!
Loading the
To load the
From the central unit’s operating menu, choose “Conference”,
“Initialise Units” and “Load Defaults” one after the other.
The text “Configuration will be overwritten. Continue?” is
shown on the display.
Press the ENTER key to replace your current configuration by the fac-
Adding a conference console to an already existing configuration
To add newly connected conference consoles to an already existing config- uration:
From the central unit’s operating menu, choose “Conference”,
“Initialise Units” and “Manual Init” one after the other.
The red signal light rings and the “Microphone active” LEDs on all conference consoles start flashing.
Choose “Add Unit”.
Only the signal light rings of the conference consoles not yet initialized remain flashing.
Press the microphone key 
of the conference consoles which you want to add to your configuration.
As soon as the initialization of a conference console is accepted by the central unit, the signal light ring of the console goes off.
Removing a conference console from an already existing configuration
To remove a conference console from an already existing configuration:
From the central unit’s operating menu, choose “Conference”,
“Initialise Units” and “Manual Init” one after the other.
The red signal light rings and the “Microphone active” LEDs on all conference consoles start flashing.
Choose “Delete Unit”.
The text “Mic. Number = 00” is shown on the display.
86
