Configuring the SDC 8200 system
Diagnostics
1Port Errors
Port Errors |
|
|
| ||
|
|
| [!] |
|
|
P1 | P2 | P3 | P4 | P5 | P6 |
Checking the communication within a cable string
To display if and on which port(s) a communications error has occured:
From the central unit’s operating menu, choose “System”, “Diagnostics” and “Port Errors” one after the other.
The ports “P1“ to “P6“ with a respective symbol are shown on the dis- play.
The symbols have the following meanings:
: A cable string with consoles is connected to the port.
: No cable string is connected to the port. If this symbol appears even though a cable string is connected to the port, check if the cable string is connected correctly.
[!]: A communications error has occured. This symbol only appears if a cable string is connected to the port.
System
2Camera Conrol
Camera Control
Status = OFF
Press ENTER to Save
System
3Control Panel
Control Panel
Status = OFF
Press ENTER to Save
Configuring connected additional components
Turning on/off a camera control
If you connect an external camera control to the central unit, you have to activate the camera control via the central unit’s operating menu.
To turn a connected camera control on:
From the central unit’s operating menu, choose “System” and “Camera Control” one after the other.
The current status of the camera control is shown on the display.
Choose “Status = ON” and press the ENTER key to save your setting.
Turning on a connected control panel
instead of controlling the SDC 8200 conference and interpretations system via a PC with software control, you can use a control panel (optional). The control panel is a miniature physical representation of your conference room, allowing you to turn on or off individual conference consoles, change the volume, change the conference mode, display the status of the inter- preter booths, etc.
The control panel will be custom tailored to your specific requirements.
To turn a connected control panel on:
From the central unit’s operating menu, choose “System” and “Control Panel” one after the other.
The current status of the control panel is shown on the display.
Choose “Status = ON” and press the ENTER key to save your setting.
