Sharp UX-A760 Fax Remote Number setting, Fax Signal Receive setting, Receive Ratio setting

Fax Remote Number setting

If desired, you can use a number other than 5 to activate fax reception from an extension telephone. You can select any number from 0 to 9.

Initial setting: 5

1Press F , , , and .

2Enter the desired number (any number from 0 to 9).

3 Press to exit.

Fax Signal Receive setting

The machine will automatically begin reception if you hear a soft fax tone after answering a call on the machine or an extension phone connected to the same line. If you prefer to turn off automatic reception, follow the steps below.

Initial setting: YES

1Press F , , , and .

2Press (YES) to turn on automatic reception.

Press (NO) to turn off automatic reception.

3 Press to exit.

Using TEL Mode

Receive Ratio setting

Note: This setting applies to all reception modes.

The machine is initially set to
automatically reduce the size of
received faxes to fit the size of the
printing paper. This ensures that the
edges of a fax are not cut off. If desired,	Receiving Faxes
you can turn this function off and have
received documents printed at full size.
♦ If a document is too long to fit on the	3.
printing paper, the remainder will be
printed on a second page. In this
case, the cut-off point may occur in
the middle of a line.
♦ Automatic reduction may not be
possible if the received document is
too large, contains too many fine
graphics or images, or is sent at high
resolution. In this case, the remainder
of the document will be printed on a
second page.
Initial setting: AUTO

1 Press F , , , and .

2 Press (AUTO) to have received faxes automatically reduced.

Press (100%) to have received faxes printed at full size.

3 Press to exit.

29