Sharp UX-P710, UX-A760 Remote Operations, Remote code, Toll Saver, Retrieving your messages

Remote Operations

Remote Operations

When you are out, you can call the machine from any touch-tone telephone and listen to your messages using the remote commands.

Remote code

To listen your messages from an outside phone, you must enter a 3-digit remote code. The remote code has been set to "001" at the factory. If you wish to use a different number, follow the steps below.

1Press F , , , and .

2Enter the desired 3-digit code.

3Press START .

4 Press to exit.

Toll Saver

When you call the machine to listen to your messages, it will answer after two rings if it has received at least one message, or after four rings if it has not received any messages.

This allows you to save money on telephone charges, particularly if you are calling long distance. If the machine does not answer after two rings, you can simply hang up before it answers, saving yourself the cost of that call.

If you do not want to use the Toll Saver function, you can turn it off by following the steps below. In this case, the machine will answer after the number of rings set with the Number of Rings setting (see page 27).

Initial setting: YES

1Press F , , , and

2Press (YES) to turn on the Toll Saver function.

Press (NO) to turn off the Toll Saver function.

3 Press to exit.

Retrieving your messages

1Call the machine from a touch-tone telephone. When your outgoing

message begins, press on the telephone.

•You will hear a short beep, and the outgoing message will stop.

•If the machine is in FAX mode, press

immediately after the machine answers (before you hear the fax tone).

Note: If the machine’s memory is full, the machine will answer after 20 rings and the outgoing message will not play. In this case, start from Step 2.

36