Sharp UX-P710 Deleting redial numbers, Storing a redial number in the phonebook, Dial Tone Check

Sending a Fax: Auto Dialling

Note: If the transmission is unsuccessful and [DOCUMENT JAMMED] appears in the display, remove the document as explained on page 18.

Deleting redial numbers

Deleting a single redial number:

1 Press		F	, and then press	F
or	F	until the number you wish

to delete appears.

2UX-P710:Press twice.

UX-A760: Press C twice.

Deleting all redial numbers:

1UX-P710: Press .

UX-A760: Press C .

2Press , .

Storing a redial number in the phonebook

1 Press F , and then F or

Fas needed until the number you wish to store appears.

2 Press F .

3Enter a name for the number (see page 7).

4 Press START .

5The number will appear. Press

START again to store it.

Automatic redialling

If you use the phonebook or a Rapid Key to send a fax and the line is busy, the machine will automatically make three redial attempts at intervals of five minutes.

During this time, [RECALLING] will appear in the display, followed by the attempt number. You will not be able to dial any other locations while the message appears.

♦To clear the message and stop

automatic redialling, press .

♦Under certain conditions, automatic redialling may stop before three redialling attempts are made.

Dial Tone Check

This setting determines whether or not the machine checks for the presence of a dial on the line before automatic dialing.

Initial setting: NO

Note: If you set this setting to YES and find that the machine is unable to dial, change the setting to NO.

1 Press F , , , and .

24