Sharp UX-A760, UX-P710 operation manual Activating the Key Lock function, Releasing the Key Lock

Activating the Key Lock function

Note: Before activating the Key Lock function, be sure to set up any Rapid Key numbers (page 21) that you wish to use after the Key Lock function is activated.

To activate the Key Lock function, hold

down F until [KEY LOCK] appears in the display.

♦If [SET LOCK CODE] appears in the display, a Key Lock code has not been stored. Store a Key Lock code and then activate the Key Lock function.

[KEY LOCK] will appear in the display while the Key Lock function is activated. Only the operations described on page 44 can be performed.

The following messages may also appear:

♦[FAX RX IN MEMORY] will appear when there is no paper in the tray and a fax has been received to memory. Release the Key Lock as explained

♦[<<<RINGING!>>>] will appear to signal an incoming call if the ringer has been turned off (page 15).

Releasing the Key Lock

Follow the steps below when you wish to release the Key Lock and operate the machine normally.

1Hold down F until [CANCEL KEY LOCK]/[ENTER LOCK CODE] appear alternately in the display.

2Enter the Key Lock code.

3Press START .

•[CANCELED] will briefly appear followed by the date and time display.

Clearing (changing) the Key Lock code

In the event that you need to clear the Key Lock code, follow the steps below.

♦If you need to change the code, first clear it and then store a new code.

below, add paper, and press

to print the fax.

START

1	Press F ,	, and	.
2

♦[COM ERROR XX]: This will appear if a line error occurs during fax reception or transmission (see page

50). Press	to clear the
message.

♦If the Caller ID function has been turned on (page 40), Caller ID information will appear when a call is received.

	Press	(CLEAR).
3	Enter the current Key Lock code.
4	Press	START .

5 Press to exit.

7. Key Lock Function

45