SMC Networks 16 10BASE-T, 100BASE-TX manual Configuring Extended ACLs

Access Control Lists 3

Web – Specify the action (i.e., Permit or Deny). Specify the source and/or destination addresses. Select the address type (Any, Host, or IP). If you select “Host,” enter a specific address. If you select “IP,” enter a subnet address and the mask for an address range. Set any other required criteria, such as service type, protocol type, or TCP control code. Then click Add.

Figure 3-35. Configuring Extended ACLs

CLI – This example adds two rules:

(1)Accept any incoming packets if the source address is in subnet 10.7.1.x. For example, if the rule is matched; i.e., the rule (10.7.1.0 & 255.255.255.0) equals the masked address (10.7.1.2 & 255.255.255.0), the packet passes through.

(2)Allow TCP packets from class C addresses 192.168.1.0 to any destination address when set for destination TCP port 80 (i.e., HTTP).

(3)Permit all TCP packets from class C addresses 192.168.1.0 with the TCP control code set to “SYN.”

Console(config-ext-acl)#permit 10.7.1.1 255.255.255.0 any 4-88

Console(config-ext-acl)#permit tcp 192.168.1.0 255.255.255.0 any destination-port 80

Console(config-ext-acl)#permit tcp 192.168.1.0 255.255.255.0 any control-flag 2 2

Console(config-std-acl)#

3-57