SMC Networks 16 10BASE-T, 100BASE-TX manual Field Attributes CLI, Basic Information

Port Configuration 3

Field Attributes (CLI)

Basic Information:

•Port type – Indicates the port type. (100BASE-TX, 1000BASE-T, or SFP)

•MAC address – The physical layer address for this port. (To access this item on the web, see “Setting the Switch’s IP Address” on page 3-12.)

Configuration:

•Name – Interface label.

•Port admin – Shows if the interface is enabled or disabled (i.e., up or down).

•Speed-duplex– Shows the current speed and duplex mode. (Auto, or fixed choice)

•Capabilities – Specifies the capabilities to be advertised for a port during auto-negotiation. (To access this item on the web, see “Configuring Interface Connections” on page 3-48.) The following capabilities are supported.

-10half - Supports 10 Mbps half-duplex operation

-10full - Supports 10 Mbps full-duplex operation

-100half - Supports 100 Mbps half-duplex operation

-100full - Supports 100 Mbps full-duplex operation

-1000full - Supports 1000 Mbps full-duplex operation

-Sym - Transmits and receives pause frames for flow control

-FC - Supports flow control

•Broadcast storm – Shows if broadcast storm control is enabled or disabled.

•Broadcast storm limit – Shows the broadcast storm threshold.

(64-95232000 octets per second)

•Flow control – Shows if flow control is enabled or disabled.

•LACP – Shows if LACP is enabled or disabled.

•Port Security – Shows if port security is enabled or disabled.

•Max MAC count – Shows the maximum number of MAC address that can be learned by a port. (0 - 1024 addresses)

•Port security action – Shows the response to take when a security violation is detected. (shutdown, trap, trap-and-shutdown, or none)

Current Status:

•Link Status – Indicates if the link is up or down.

•Port Operation Status – Provides detailed information on port state. (Displayed only when the link is up.)

•Operation speed-duplex– Shows the current speed and duplex mode.

•Flow control type – Indicates the type of flow control currently in use. (IEEE 802.3x, Back-Pressure or none)

3-63