Editing 5 Chapter
Setting the edit points and player speed
Use the following procedure.
Z
| 2,6,7 | 8 | 4 | 1 5 | 3 | 6,9 |
1Press the ASSEMBLE button or the desired INSERT button to select the editing mode.
2Press the DMC EDIT button.
This unit switches to the DMC editing mode, and the DMC EDIT button lights.
3Press the RECORDER button.
4Holding down the ENTRY button, press the IN or OUT button to set an edit point.
5Press the PLAYER button, to set the player IN point.
Note
It is not possible to set the player OUT point.
6Holding down the DMC EDIT button, turn the search dial, to set the initial speed.
To select normal speed as the initial speed, press the PLAY button.
The speed you set appears in the speed indication area.
7When the initial speed setting is complete, release the DMC EDIT button.
8Press the PREVIEW button.
The tape is prerolled and then the recorder starts operating at normal speed and the player at the set initial speed.
9On passing the IN point, the MEMORY indicator begins to flash: turn the search dial to vary the playback speed.
While the MEMORY indicator is flashing, the speed variations are stored in memory. On passing the OUT point, the MEMORY indicator changes from flashing to continuously lit, and the variable speed storing ends.
If the MEMORY indicator lights continuously before the OUT point
This indicates that the memory became full at that point. Thus even before the OUT point is reached, it is not possible to record more speed variation.
The maximum capacity is a duration of 120 seconds.
Quitting the DMC edit mode
Press the DELETE button and DMC EDIT button simultaneously.
Executing the DMC edit
Press the AUTO EDIT button.
DMC editing is carried out at the stored varying speed. Once the editing is carried out, the stored speed variation is lost from memory.
To check the editing results
Press the REVIEW button.