AUDIO IN CH1 or CH2 connector is automatically selected when an audio cable is connected to the AUDIO IN CH1 or CH2 connector. In such a case, set REAR XLR AUTO to OFF on the
•When the LINE/AES/EBU/MIC switch is set to LINE or MIC, the audio signals recorded on audio channels 3 and 4 are not affected by the XLR automatic detection function. They are determined by the settings of the AUDIO IN
To fit the
1 Attach the WRR tuner fitting (not supplied; service part number:
1Use a Phillips type screwdriver to tighten the four screws placed in the tuner fitting. For three of these screws, insert the screwdriver through the corresponding hole and tighten the screw.
Note
Make sure that all four screws are fully tightened.
2Loosen the adjustment screws on the tuner fitting.
3Adjust the tuner fitting position for a
Pack to be attached, and tighten the adjustment screws to fix its position.
4Attach the mount plate supplied with the
About the WRR tuner fitting (service part number:
Adjustment screws
Mount plate (supplied with
Phillips type screwdriver
2 Attach the battery pack.
On how to attach the battery pack, see “To attach the battery pack” on page 35.
3 Mount the tuner on the WRR tuner fitting.
4 Connect the tuner power cord to the DC OUT connector of the camcorder, and the audio output cable to the AUDIO IN CH1 or CH2 connector.
5 Set the switches as follows.
•Set the LINE/AES/EBU/MIC switch for the channel to which the audio output cable is attached to MIC.
•Set the AUDIO IN
If the XLR connection automatic detection function is on, the input signal for audio recording is selected automatically, and therefore this setting is not required.
Preparations 2 Chapter
Preparing the Audio Input System 47