Appendix

Important Notes onOperation

Use and storage

Do not subject the unit to severe shocks

The internal mechanism may be damaged or the body warped.

Do not cover the unit while operating

Putting a cloth, for example, over the unit can cause excessive internal heat build-up.

After use

Always turn off the POWER switch.

Before storing the camcorder for a long period

Remove the battery pack.

Shipping

•Remove the disc before transporting the unit.

•If sending the unit by truck, ship, air or other transportation service, pack it in the shipping carton of the unit.

Care of the unit

Remove dust and dirt from the surfaces of the lenses or optical filters using a blower.

If the body of the unit is dirty, clean it with a soft, dry cloth. In extreme cases, use a cloth steeped in a little neutral detergent, then wipe dry. Do not use organic solvents such as alcohol or thinners, as these may cause discoloration or other damage to the finish of the unit.

In the event of operating problems

If you should experience problems with the unit, contact a Sony representative.

Use and storage locations

Store in a level, ventilated place. Avoid using or storing the unit in the following places.

•In excessive heat or cold (operating temperature range: 0°C to 40°C (32°F to 104°F))

• Remember that in summer in warm climates the

temperature inside a car with the windows

 

closed can easily exceed 50°C (122°F).

Appendix

• In damp or dusty locations

 

• Locations where the unit may be exposed to rain

 

• Locations subject to violent vibration

 

• Near strong magnetic fields

 

• Close to radio or TV transmitters producing

 

strong electromagnetic fields.

 

• In direct sunlight or close to heaters for

 

extended periods

 

To prevent electromagnetic interference from portable communications devices

The use of portable telephones and other communications devices near this unit can result in malfunctions and interference with audio and video signals.

It is recommended that the portable communications devices near this unit be powered off.

Note on laser beams

Laser beams may damage the CCDs.

If you shoot a scene that includes a laser beam, be careful not to let the laser beam be directed into the lens of the camera.

Condensation

If you move the camcorder from a very cold place to a warm place, or use it in a damp location, condensation may form on the optical pickup. Then, if the camcorder is operated in this state, recording and playback may not be performed properly.

Do the following to prevent this from happening.

•When you move or operate the camcorder in an environment where condensation may form, be sure to load a disc in advance and close the disc compartment lid.

•Whenever you turn on the power, check that the HUMID indicator does not appear on the color LCD. If it appears, wait until it disappears before loading a disc.

For details, see “Loading and unloading a disc” on page 73 and “Operation Warnings” on page 215.

Important Notes on Operation 223