Use the GENLOCK page of the MAINTENANCE menu to adjust the genlock
Chapter | ||
| ||
| • This connector also inputs a return video signal. | |
1 | You can display the | |
viewfinder screen while holding the RET button | ||
Overview | ||
menu. | ||
| down with RETURN VIDEO set to ON on the | |
| ASSIGNABLE SW page of the OPERATION | |
| • Input an external video signal. When the | |
| optional | |
| Board is installed, the unit can record analog | |
| composite video signals that are input to this | |
| connector. |
eTC IN (timecode input) connector (BNC type)
To apply an external lock to the timecode of this unit, input the reference timecode.
For details of timecode, see “Setting the timecode” on page 68.
fTEST OUT connector (BNC type)
This connector outputs the video signal for a video monitor. The output signal can be selected from composite video,
If the output signal is set to one of R, G, or B, then this setting changes to
Depending on menu settings, menus, timecode, and shot data can be superimposed on the image on the monitor. This connector can also be used to synchronize the timecode of an external VTR with the timecode of the camcorder.
gTC OUT (timecode output) connector (BNC type)
To lock the timecode of an external VTR to the timecode of this unit, connect this connector to the external VTR’s timecode input connector.
28 Locations and Functions of Parts and Controls
Rear
1
2
3
4
5 6 7
| AES/EBU | AUDIO IN | LINE | AES/EBU |
|
| LINE | MIC | MIC |
| |
|
| 48V |
| 48V |
|
| DC OUT | OFF |
| OFF | AUDIO OUT |
| 12V |
|
|
| |
DC | 0.5A |
|
|
|
|
IN |
|
|
|
|
|
| SUPER |
|
|
|
|
| CH1 | CH2 |
|
|
|
| 1/2 | 3/4 |
|
|
|
SDI OUT | SDI OUT |
|
|
|
|
8 9 0 qa qs qd
aTALLY (back tally) indicator (red)
Lights up during recording. It will not light if the TALLY switch is set to OFF. This indicator also flashes to indicate warnings (see page 21) in the same manner as the REC/TALLY indicator in the viewfinder.
For details, see “Operation Warnings” on page 215.
bTALLY switch
Set to ON to activate the TALLY indicator function.
cUSB connector
This is a USB 2.0 connector.
Connect a Windows USB keyboard or mouse (see page 110), or a USB flash drive to access planning metadata stored on the drive (see page 121).
d (network) connector
This is a